Oil Reset
It allows you to perform reset maintenance mileage and data intervals for a new calculation of Engine Oil Life system once changed
the oil.

TPMS
It makes tpms sensor in displaying sensor IDs from the vehicle’s ECU, inputting TPMS   replacement IDs and activate tpms
sensors.

Injector Adjust
Diesel injector code needs programming ID and parameters to the ECU for accurate communication and Injection control system.

EPB
It is important in the maintenance of electronic braking system’s safety and efficiency when replace brake pad or motor.

DPF
It works for Diesel Particulate Filter system with DPF regeneration, DPF component replacement teach-in and DPF teach-in after
replacing the engine control unit.

TPS/ThrottleSensor
Vehicle’s throttle position system sensor connected to the butterfly spindle and is primarily used to monitor the throttle
position within an inner combustion engine. Due to its location, the throttle position sensor is able to effectively observe where
the throttle butterfly valve is positioned.

ABS Bleeding
The auto bleed procedure is used on BOSH 5.3 equipped vehicles. This procedure uses a scan tool to cycle the system solenoid
valves and run the pump in order to purge the air from the secondary circuits.

SAS
It helps clear the fault steering angle sensor memories and plays an important role in the steering angle sensor calibration.

Battery Test
It allows the scan tool to evaluate the battery charge state, monitor the close-circuit current, register the new battery
replacement, and activate the rest state of the vehicle battery system

CVT Learning
This function is used to reset the compensation code and initialize the ECT after a solenoid value or value body assembly has been
replaced.

Gear Learning
The scan tool monitors certain Camshaft position sensors signals to determine if all conditions are met to continue with the
procedure for Engine running.

Odometer Management
This function allows you revise the date of odometer and write the original date into new odometer.